building operable shutters from composite/azek
2009年1月11日 · Re: building operable shutters from composite/azek Try timberlane shutters.. they make both wood and synthetic. You could make your own raised panel shutters with a router table,shaper or table saw depending on the profile to make the raised panels and then tounge and groove the stiles and rails..
Light weight Azek boards/panels? - JLC-Online Forums
2016年6月9日 · I know there is lightweight PVC pipe, where they inject tiny air bubbles in the material. Does anyone make PVC boards/panels with the same technique?
Azek panels - JLC-Online Forums
2005年7月8日 · Moderator: Bill Robinson Durable and leak-free details for siding and trim, doors and windows, roofs, decks and exterior finishes.
Azek buildups - JLC-Online Forums
2013年7月31日 · The frame and panel could be built with a cope and stick bit using 1/4" Azek for the panels. That way the panels could be independent of the frame. One thing about Azek is that it is really flimsy. You need a very solid backer behind it or forget about it. I'm guessing the way those columns are built there must be some kind of base detail.
PVC (Azek) vs Cement Board (James Hardie) - JLC Online
2010年5月7日 · Re: PVC (Azek) vs Cement Board (James Hardie) I also cracked an Azek fascia board by nailing through it with a gutter spike, I think the rafter tail was a bit soft so the azek bounced around a bit. However, on the bright side, all my Azek made it through the 3' of snow including the gutter in question. Live and learn.
Azek or Trex Sheets - JLC-Online Forums
2008年9月10日 · Panels are also attached to wrb with vertically troweled construction adhesive. Stiles were assembled with azek pvc cement and pocket holes from the back and attached by section as a unit. Water table and cap was preassembled with cement and pocket holes by section and installed over strips of the panels 16" oc to create a rain screen behind ...
Hardie-panel and Azek - JLC-Online Forums
2008年5月24日 · I am building a barn and using hardie-panel and azek batten. I will be nailing the hardie-panel on to 1/2 zip system with 2 3/8 ring nails @ the studs. I was then going to nail 3 1/2" wide x 5/8" azek trim on the studs as batten. I was going to use 2 1/2" 16ga ss trim nails for the azek to the hardie-panel.
Azek beadboard ceiling - JLC-Online Forums
2009年9月18日 · Re: Azek beadboard ceiling I'm planning to use Azek 5-1/2" beadboard for a soffit that enlarges out into a 2nd floor balcony ceiling extending 4 feet out from the main house for a portion of the run. The 5-1/2" beadboard needs two nails per 2x4 crossing. Plus the max span for it is 12", so I'll have to add additional pieces since I'm 16" OC now.
Azek vs. MDO paneling - JLC-Online Forums
2009年9月25日 · Moderator: Bill Robinson Durable and leak-free details for siding and trim, doors and windows, roofs, decks and exterior finishes.
Azek Recessed Panel Newel Posts - JLC-Online Forums
2006年5月15日 · Your azek plan sounds pretty good to me, we are figuring a similar project coming up, it is a deck and railing that does not have any roof protection. On ours, the sunken panels will have an applied molding rather than cope and stick, our plan was to strategically drill holes and use expanding foam to lock the covers in place after final alignment.